Close Please enter your Username and Password
Reset Password
If you've forgotten your password, you can enter your email address below. An email will then be sent with a link to set up a new password.
Cancel
Reset Link Sent
Password reset link sent to
Check your email and enter the confirmation code:
Don't see the email?
  • Resend Confirmation Link
  • Start Over
Close
If you have any questions, please contact Customer Service

posts

Member Deleted Post


This post has been deleted by

drmgirl622 68F  
25821 posts
12/10/2016 5:57 am

Good luck to you in your venture ! Working and raising cattle is not an easy task.....I dreaded those summer months in PA throwing bales of hay.


twosharp2 79M
767 posts
12/10/2016 7:27 am

I have my father's very old branding irons displayed on a wall; they have not been registered with the state for many years. Also have dehorner tool; it's about 5´long with gear mechanism for cutting leverage (even looks wicked). Have a solid brass windmill valve which mounts at the bottom of the sucker rods, cow hobbles to restrain them from kicking while milking, plow sweeps, and cream separator.

Many will not understand the terminology and implements, but you may.



Become a member to comment on this blog