Close Please enter your Username and Password
Reset Password
If you've forgotten your password, you can enter your email address below. An email will then be sent with a link to set up a new password.
Cancel
Reset Link Sent
Password reset link sent to
Check your email and enter the confirmation code:
Don't see the email?
  • Resend Confirmation Link
  • Start Over
Close
If you have any questions, please contact Customer Service

karlrayner 46M
0 posts
6/30/2016 12:32 am
My Chastity Conundrum.

So I revealed to a close friend that I had once indulged in a little chastity play, many years ago and only for a very short time.

She was intrigued and wanted us to give it a go. So in an effort to surprise her I did a little window shopping and eventually purchased a CB6000. It arrived and I wanted to give it a go straight away, but to my surprise it was just too small, even after I let my initial excitement die down! it was still to small to squeeze me inside.

So I went back to the sellers website and chatted online with a nice sales assistant. She explained that I had brought a CB6000 short and that there was a larger version. Undeterred and at my slightly disappointed friends insistence, we purchased the larger version.

3 days later and the new devise arrived, and this one did not fit either. After several attempts, including some lubricant and even some ice to shrink things down, it seems that even at my most "soft" I am just a little bit too girthey to fit in. Back to the sellers website to see if they can help. After checking through the other devises the online assistant tells me that looks like the largest one they do.

"Would I prefer a sleeve without a lock?"

"Well no not really the lock is really the whole point of the devise, isn't it?"

"Humm yes I see your point, Oh dear she says, Too big for a chastity devise, I don't think we've ever had that complain before!" and laughs to herself. I appreciate her humour but now I don't know where to go with this problem.

Ideally I would prefer plastic, the large has a diameter of 1.375inches, we estimate I need closer to 1.5inches.

Unless there is a trick to getting in that I am not aware of?

Any ideas??



Become a member to comment on this blog